So follow the owners guide, and if youve lost it already, request another copy of the same from the business. And to detect the fault better and faster, decide to repair your ac unit on a day that is relatively warm.
Be sane while you repair it. Cut off the power flow to the system while you are at it. The cooling unit typically has a switch off panel for this. However, just in case you dont find any such panel, cut off the electricity to the whole house for that time. Also, rake away all debris from the condenser outside while you start the cleaning task.
The very first step to finding where the fault is is to take the grill cover off the condenser. Then, clean the blades or fins with a soft brush or some soft material, making sure to see that you dont harm the fragile fins in any way. After cleaning these, you need to dry them. Next, remove the screws and take out the grill-cover very carefully, because the fans remain affixeded to them, and you might unintentionally pull loose some wires. Then you need to hose out the fins, keeping the motor covered with some water-resistant material.
Considering that you have already dismantled your ac unit so much, you may as well lube the motor a little in this circumstance Green Bay Wisconsin Air Conditioning Repair . Lastly, put back all the parts in their right places, and you are done with a brief and easy ac unit repairing effort.
Now, to see if youve actually set all of it right, switch the power on and let the machine run for some time. Put your hands on the two pipes connected to the condenser. If one is warm and the other is cool, your system is all right. However, if it isnt so, maybe you need to charge the refrigerant. And this cant be done alone. So call a professional.
If your cooling unit does not turn on automatically, you might look into the following steps. First, guarantee that the thermostat is set to cool, and is below the room temperature. Second, a blown-out fuse might also be the reason as much as a tripped breaker on the main panel. Third, keep the power switch on the heater and the condenser switch on the outside switched on. Fourth, but not least, guarantee that the 240-volt disconnect is not shut off. It is placed just next to the outside compressor.
